Hi, I replaced my battery, and since then the display screen between the odometers has been black. Anyone know how to get it back? There are fuse boxes on both the front cabin left and right side (pax and driver region) panels. The doors cover them when closed near the hinge points. The panels are ...

Hi thanks for your help P2111 fault is throttle actuator stuck open but it cant be as car runs/idles perfect have swapped throttle body and throttle position sensor can I ask what software you use to go into these Qashqai I use a generic scanner as yourself. I went to a local ATS Euromaster garage ...

Those Codes are not in Nissan diagnostics for for the K9K engine.

However, P0120 is for throttle position sensor and P2119 is Electric throttle control actuator

Likely both of those will initiate Stop/Start disable

Not very helpful

hi guys new to the forum and this has probably being posted somewhere on the site basically both my abs and traction control lights are on and unsure why i have put obd on it to read codes and i get p0530 and p0380 first one being pressure sensor of ac refrigerant is out of range and the second cod...

hi guys new to the forum and this has probably being posted somewhere on the site basically both my abs and traction control lights are on and unsure why i have put obd on it to read codes and i get p0530 and p0380 first one being pressure sensor of ac refrigerant is out of range and the second cod...

Difficult to be accurate really. From your pics I think I would look closely at the tyre pressure fault first and eliminate that. You should check all tyre pressures with a tyre pressure gauge. Make sure they are correct. Thats a safety issue for one. The other faults are present probably because of...

Calnorth, you were correct the fault codes came back, however, I did notice when connecting my scanner that there are 2 ecu's. The first showed no faults, the second showed 2 which unfortunately I erased before reading them oops. No doubt they will reappear so will read the then. But, 2 ecu's? .......

BCM is not a good place to go...its a very, very expensive unit and no diagrams exist for it..including wiring. I also connected to the wiper supply..(passenger side fuse box). Need to remove glove box and side covers. That is a fuse piggy back job and ensures power off when ignition off. Leaving a ...

Update, cleared the DTC from the ECU and all is now working normal again, must have been a glitch but I will keep my eye on it. Errors can return because the ECU continually checks for faults and counts any such occurrences over time. It often takes about 3 cycles or starts of the engine to finally...

Qashowner wrote: ↑Sat Oct 15, 2022 11:23 am Put my trusty scanner on the car this morning and had P0380, glow plug fault. That was the only code. Would that be related to my other problems?

If that is truly the fault its an engine problem that will disable stop/start