Query on new QQ order

Ordering, Tracking, Delivery Information
Posts: 6782
Joined: Wed Mar 19, 2014 12:39 pm
Location: Berlin, Germany
Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–present)

Re: Query on new QQ order

Post by DaveBerlin » Mon Mar 16, 2020 9:18 pm

Consub, I have the ECO facility also but must admit I have not used it as the 160PS + DCT is an absolute dream to drive normally. I have attached a few comments on the ECO Mode but most basically US Nissan Based with a CVT Box but never the less might be of some help - Dave 🙂

Eco Mode | NISSAN | TECHNOLOGICAL DEVELOPMENT ACTIVITIES : https://www.nissan-global.com/EN/TECHNO ... eco_m.html





Regarding the Seating I believe you will find this is only on the Tekna + :



11.19/1.3L/160PS/Tekna+/DCT/PrOPILOT/KAD Gun Metallic/Trunk Lower Finisher/Rear Glass Finisher/Ambient Lighting-LED’s Innen/Entry Guards Illuminated/Sport Pedals/Front Styling Plate/LED No.Plate/Chrome Door Handles/Rear Valance/Giacuzzo Alloys + Falken

Posts: 17
Joined: Sun Mar 31, 2019 8:58 am
Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–present)

Re: Query on new QQ order

Post by Oz_Qai » Tue Mar 17, 2020 4:54 am

So am I right to say that the speedo unit in the Qashqai can be re-calibrated?

Posts: 13
Joined: Wed Feb 26, 2020 7:54 pm
Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–present)

Re: Query on new QQ order

Post by consub » Tue Mar 17, 2020 2:59 pm

Hi Dave Berlin,
I had read all about how the eco mode works, and my query is that when selected there is no indication on the drivers display. I have seen this mentioned by others, and have never seen that question answered. If it is a fault, I will mention it when the car goes in for service. I could try the acceleration on two drives after pushing the switch and see if there is a difference, isolating the fault to the switch or the computer, but reading others comments it seems there may not be much difference. I suspect there is a faulty switch or disconnected wire. I might feed back some comments regarding the handbook as it is not very well written resulting in ambiguities.
The drivers seat entry/ exit feature is only on the automatic and that's what mine is, I suspected that it is only on the memory seats, which are also available on the Tekna as an extra, but it is not clear in the handbook, perhaps it would be better written with clear instructions, replacing the generic "if fitted" notes all over the book.
Regarding the speedo calibration, the dealers have a plug in box that allows them to change the computers wheel size store, amongst other items. this is used by the computer to calculate and display the speedo reading.
I was a development engineer on Concordes engine digital intake control computers in the early 70s. Hence my interest.

Post Reply