Hey qashqai forums, RT Here this is my first post.
I have recently had a few problems with my windscreen wiper motor so I replaced that today and put everything back together I have managed to get my wipers to the original position and they are doing the full sweep of the windscreen but when the wipers are turned off the are basically sitting in the middle of my windscreen as if they’ve done 50% of the sweep and just stopped there instead of stopping at the bottom of the windscreen like previous.
If anyone could help me and point me in the right direction it would be much appreciated!
Thank you. RT412
Windscreen wipers resting position
- Gel
- Posts: 3265
- Joined: Thu May 22, 2014 12:02 pm
- Location: Thames Valley UK
- Qashqai Model: Mk.2 Qashqai - J11 (2013–2017)
Always try forum's SEARCH box first for an answer; many previous posts on this.
2014-19 J11A-14 1.5dci Ink Blue Tekna owner; now departed for a Mazda CX-5 GT Sport Nav, 2.0L Petrol
-
- Posts: 336
- Joined: Sat Feb 23, 2019 7:27 am
- Qashqai Model: Mk.3 Qashqai - J12 (2021+) New Model
If you put it on intermittent do they pause in the correct position of the screen ?
Hi lewis, no they do not always the same position pretty much mid wipe.lewisbryant wrote: ↑Sun Jan 17, 2021 5:36 pm If you put it on intermittent do they pause in the correct position of the screen ?
-
- Posts: 336
- Joined: Sat Feb 23, 2019 7:27 am
- Qashqai Model: Mk.3 Qashqai - J12 (2021+) New Model
Then the arm bolted to the motor is in the wrong position.
You need to make sure the motor is in park so do a wipe and let it park in mid screen if it wants to, turn them off and the ignition.
Then undo the nut for the arm from the motor without turning the motor and lift the arm off the motor then with the other hand put the wipers to the park position and then put the arm back on the motor and the nut and try that
If I remember rightly the arm will sit about 3 o'clock on the motor spindle and the nut will have to be done up with a spanner to pinch it then you can move the wipers and tighten it properly then
Hope this makes sense
You need to make sure the motor is in park so do a wipe and let it park in mid screen if it wants to, turn them off and the ignition.
Then undo the nut for the arm from the motor without turning the motor and lift the arm off the motor then with the other hand put the wipers to the park position and then put the arm back on the motor and the nut and try that
If I remember rightly the arm will sit about 3 o'clock on the motor spindle and the nut will have to be done up with a spanner to pinch it then you can move the wipers and tighten it properly then
Hope this makes sense