Light Conversion
-
- Posts: 2
- Joined: Fri Nov 28, 2014 10:22 pm
Hi I'm new to all this was just wondering if anyone has bought a aftermarket xenon 10,000k HDI kit off of ebay and went to fit it today. When i got the original bulb out i noticed that the connectors are different to original wiring does anyone have any suggestions as to get around this or is it not possible?
Michael Edmond
-
- Posts: 140
- Joined: Sun Sep 21, 2014 5:00 pm
Yes it's possible I did it in my original QQ , just got to mess about splicing the wiring in without cutting into the loom preferably , I wouldn't go with 10000k , your going to attract the wrong kind of attention ....
-
- Posts: 2
- Joined: Fri Nov 28, 2014 10:22 pm
So do I need to cut any wires? My QQ is a 61 plate. Can someone give me a run down on what I need to do.
Michael Edmond
-
- Posts: 121
- Joined: Fri Jan 11, 2013 9:25 am
I find the 2014 lighs very poor and was contemplating fitting the HID but perhaps the 4300 and only to the near side . I have had landrovers with bad lights and fitting a 100w to the nearside was the solution..I thik a 100w in a QQ will; melt the fittings.
pistnbroke2014-11-29 14:06:07
pistnbroke2014-11-29 14:06:07