Page 17 of 85
Re: FIRMWARE VERSION
Posted: Sun Dec 09, 2018 3:53 pm
by duncho
send me PM including VIN of your car and your email
Re: FIRMWARE VERSION
Posted: Sun Dec 09, 2018 5:47 pm
by Ivan_Nieto
Done
Enviado desde mi LG-H930 mediante Tapatalk
Re: FIRMWARE VERSION
Posted: Thu Jan 03, 2019 3:59 am
by leguyanais
Hello everyone,
I come to you to know if I can upgrade my version.
If it is possible that it would be the manipulation to perform.
Thank you for your help
Re: FIRMWARE VERSION
Posted: Thu Jan 03, 2019 8:11 am
by duncho
Nope, you have LCN2Kai EVO version (newer unit).
Re: FIRMWARE VERSION
Posted: Thu Jan 03, 2019 8:46 pm
by leguyanais
duncho wrote: āThu Jan 03, 2019 8:11 am
Nope, you have LCN2Kai EVO version (newer unit).
Thank you for your answer.
Will there be an update?
Is it possible to activate voice commands because they are disabled?
Re: FIRMWARE VERSION
Posted: Thu Jan 03, 2019 11:26 pm
by duncho
leguyanais wrote: āThu Jan 03, 2019 8:46 pm
Will there be an update?
Is it possible to activate voice commands because they are disabled?
Only Nissan knows
Re: FIRMWARE VERSION
Posted: Wed Jan 09, 2019 11:31 pm
by nickc78
AndyW wrote: āFri Mar 23, 2018 7:36 pm
Hey all, any ideas what Iām doing wrong?
Hi,
I also got the error message that says "please use NissanConnect software download image only", any idea why? My stick USB is formatted Fat32 and I had the same folder structure in it as per the photo earlier in this thread and followed the instructions as per the guide. This message pops up almost immediately after hitting the update button.
Regards
Nick
Re: FIRMWARE VERSION
Posted: Fri Jan 11, 2019 7:57 pm
by robthg
If you want to update the firwarm whilst driving, the hazard lights have to be on?
Re: FIRMWARE VERSION
Posted: Fri Jan 11, 2019 8:24 pm
by duncho
No need, engine needs to be on and must not be turned off. Switch S/S off!!!!
Re: FIRMWARE VERSION
Posted: Fri Jan 11, 2019 8:54 pm
by robthg
Thanks for the quick reply. Still unsure at which step i can start the motor, turn off hazard lights and drive...
1. Unzip file to blank USB stick.
2 For IKey vehicles press the start/stop button once to enter "Ignition On" mode. Lower the drivers window to the down position. Press the hazard light switch to "ON" position and ensure the hazard lights are activated.
3. Insert the USB memory stick
4. Press and hold the "Setup" button and then turn the "Enter" button a half turn anticlockwise, then a half turn clockwise, then a half turn anticlockwise. The service menu will then appear. Release the "Setup"
5. Press the "Version" button on the screen.
6. Press the 'Update System Software' button. ' Press 'OK'.
7. will state 'Download Media Found'. Press the 'Update' button on the Nissan Connect screen.
8. After a 5 minute period, the screen will become active and a "Reading Medium" message will appear.
9. After the reprogramming update has finished a message will appear stating "Please remove USB Stick. System is shutting down". Remove
the stick. The screen may remain on this screen for up to 5 minutes. This is normal DO NOT alter the ignition position.
10. Press the "Accept" button. The reprogramming operation is now complete.