Hi all
My wifes Qashqai (2011) is causing me headaches!!
All brake lights have failed and no warning lamps present on dash
Checked fuses
Check brake pedal switch
both ok and volts present at pedal
Help!!!!!!
Electrical gremlins - really stuck
-
- Posts: 3
- Joined: Sun Oct 01, 2017 11:40 am
- Qashqai Model: Mk.1 Qashqai Facelift - J10b (2010–2013)
-
- Posts: 3
- Joined: Sun Oct 01, 2017 11:40 am
- Qashqai Model: Mk.1 Qashqai Facelift - J10b (2010–2013)
All lights are led and no volts at connectors. volts present at brake switch
- Hound
- Posts: 1163
- Joined: Tue May 19, 2015 12:37 am
- Location: Deeside
- Qashqai Model: Still looking for one....
Ok... there's only one fuse (#11, 10A) and there's not really much in the circuit (this one is from pre-facelift, so shows incandescent bulbs, but probably there's no other difference). Maybe a failed LED or a wire break somewhere - continuity between brake switch and brake lamp contacts??
Used to have 2015 1.6dCi 130 Xtronic N-tec+ in Gun Metallic
-
- Posts: 3
- Joined: Sun Oct 01, 2017 11:40 am
- Qashqai Model: Mk.1 Qashqai Facelift - J10b (2010–2013)
Yes could well be a break in the wiring Im guessing? DIfficult to find however.
My wife did crack the rear light outer housing - maybe water has got in and done some damage somewhere
I've replaced the unit but still not working
Im wondering if I have damaged the BCM???
My wife did crack the rear light outer housing - maybe water has got in and done some damage somewhere
I've replaced the unit but still not working
Im wondering if I have damaged the BCM???
- Hound
- Posts: 1163
- Joined: Tue May 19, 2015 12:37 am
- Location: Deeside
- Qashqai Model: Still looking for one....
I did think of the BCM but thought there'd be more faults than just brake lights if it was damaged. There doesn't appear to be a BCM fuse in the cabin fusebox, like on the J11.
You should be able to test continuity between each stop lamp positive side and pin 2 of the stop lamp switch. Checking the ground connections would eliminate them too.
Good luck!
You should be able to test continuity between each stop lamp positive side and pin 2 of the stop lamp switch. Checking the ground connections would eliminate them too.
Good luck!
Used to have 2015 1.6dCi 130 Xtronic N-tec+ in Gun Metallic