Hi,
Our 360 developed condensation on the inside of the offside rear lamp pretty much as soon as we got it but I thought it was just that.
Today I just got it back from the garage after a hefty £700 bill for a service, couple of tyres and all new brakes and noticed that it wasn't working properly. I removed the lamp and noticed its got black cr@p at the bottom from stagnant water and about an inch of water sat at the bottom.
I emptied the water out but I can't get inside the clear the lense.. its glued and water was all over the circuit board for lower part of the lights.... a couple of the led's fell off too so I reckon its toast.
Is it possible to get the outer casing off the lamp to get inside and clean the lamp?
I've looked on eBay and a new lens is about £60 but not sure if it comes with the board to replace it... and worried the seal will be as bad as this one.
Rear lights - water damage
