Thank you so much for this details Hound. I’m really grateful. I’m a right that you did not placed an extra fuse on the « - » wire which sounds logical as the power goes through the « + ».
Can’t wait to tackle this one.
Still hesitating though were to place the socket itself. The flat parts on the hard plastic ventilation covers in the boot are already taken by LED strips. Maybay I’ll use the soft bootliner if there is enough space behind but I don’t want to stress the cutouts everytime while deplugging the 12v...
12 volt socket ?
- lapalmeraie
- Posts: 386
- Joined: Tue Mar 28, 2017 5:11 am
- Location: Belgium
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
- Contact:
Qashqai J11b 2020 N-TEC - 1.3 DIG-T 140PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
- Hound
- Posts: 1163
- Joined: Tue May 19, 2015 12:37 am
- Location: Deeside
- Qashqai Model: Still looking for one....
I fitted the 12v socket on the same RH panel where you placed your LED strip, but lower down. Unless you
added more strips after the one shown in this photo, there should be room for you to put a socket as well.
added more strips after the one shown in this photo, there should be room for you to put a socket as well.
Used to have 2015 1.6dCi 130 Xtronic N-tec+ in Gun Metallic
- lapalmeraie
- Posts: 386
- Joined: Tue Mar 28, 2017 5:11 am
- Location: Belgium
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
- Contact:
Is that I photo of my boot?
It is indeed actually like that and then that place would be perfect.
Thanks
It is indeed actually like that and then that place would be perfect.
Thanks
Qashqai J11b 2020 N-TEC - 1.3 DIG-T 140PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
- lapalmeraie
- Posts: 386
- Joined: Tue Mar 28, 2017 5:11 am
- Location: Belgium
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
- Contact:
I finally managed to find some time to effectuate this mod. Works like a charm
[youtube]N3dBNCo1awg[/youtube]
[youtube]N3dBNCo1awg[/youtube]
Last edited by lapalmeraie on Mon Jun 18, 2018 8:00 am, edited 2 times in total.
Qashqai J11b 2020 N-TEC - 1.3 DIG-T 140PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
- Hound
- Posts: 1163
- Joined: Tue May 19, 2015 12:37 am
- Location: Deeside
- Qashqai Model: Still looking for one....
If I'd known where to pick up trailer wiring I would probably have done that - tapping into the rear of the console 12V socket was a "quick and dirty" solution as I didn't intend to run any high-draw items from the new boot socket.
I removed the rear seat squab in order to easily route the wiring from inside the boot panel and under the carpet.
I removed the rear seat squab in order to easily route the wiring from inside the boot panel and under the carpet.
Used to have 2015 1.6dCi 130 Xtronic N-tec+ in Gun Metallic
-
- Posts: 192
- Joined: Mon Nov 13, 2017 7:14 pm
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
There are two 12v sockets and both eventually shut down after about 5 mins as I have two dash cams running off them and they wouldn't switch off if they were live all the time. A one in the boot would have been useful.
2020 Tekna 1.3 DCT Auto, Pearl Black, Pan Roof, Heated Screen, ss door sills, Chrome door handle covers, ss Reg Plate frames, Gas Bonnet struts, chrome wheel nut covers, black side protection strips.
- lapalmeraie
- Posts: 386
- Joined: Tue Mar 28, 2017 5:11 am
- Location: Belgium
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
- Contact:
My outlet in the front is continue and could also be tapped instead of the actual one. Same procedure but just have to draw the cable a bit further
Qashqai J11b 2020 N-TEC - 1.3 DIG-T 140PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
Qashqai J11a Connect Edition 1.6 DIG-T 163PS
Anyone know if and where this live 12v for the trailer is to be found in a J10 version? I suppose it must be somewhere behind the sidepanel left or right in the rear, a quick look there didn´t help. What to look for exactly? Colour, 1,5mm or more wire? I need a live wire for my caravan and would like to avoid installing a long wire from up front. Besides Nissan must have thought about this for people who want to install a 13 pin socket, or did they?
Thanks.
Thanks.
- calnorth
- Posts: 2719
- Joined: Mon Feb 11, 2019 2:01 pm
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
Have a look at this J10 Power Supply document.....Page PG-41 Wiring Diagram - ACCESSORY POWER SUPPLY
It may not be 100% correct but seems to match some of the comments on this thread about Fuses
.......................................
It may not be 100% correct but seems to match some of the comments on this thread about Fuses
.......................................
- pg.pdf
- (1.24 MiB) Downloaded 154 times
Mk2 Qashqai Facelift - J11b (2017–and onward)
1.6 Dig-T N-Connecta
1.6 Dig-T N-Connecta