Nissan QashQai Forums

Hello,

Does anyone have a plan for the electrical wiring of the accelerator pedal for QASHQAI 1,6 DIG-T.
I have it for J10, but I can't find it for J11.
I can also ask otherwise.
Is the accelerator pedal at 1.6 DIG-T (MR16DDT 2018) connected in the same way as at 2.0 16V (MR20DE 2011)
I have BLITZ THROTTLE CONTROLLER for MR20DE and I wonder if I can use it on my MR16DDT?

Don't think anybody can accurately answer your questions. Detailed ECU info is'nt available but what I have seen is two sensor (potentiometer) inputs of 3 wires each.

calnorth thanks for the reply.
It's true. In the J10, there are two potentiometers with three wires each.
The BLITZ THROTTLE CONTROLLER is connected as an interface between the pedal and the ECU.

The figure shows the connection diagram for the MR20DE.
Now I’m just wondering if the J11 with the MR16DDT engine has the same wire placement on the pedal connector.