Roof liner route for dashcam

Bodywork & Interior problems
Post Reply
Mark65
Posts: 102
Joined: Wed Jun 23, 2021 7:55 am
Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)

Post by Mark65 »

Hi all,
Does anyone know if you can run a pull rod through the roof liner for a rear dash cam, either coax or power?, or a route at floor level, I want to keep clear of airbags.
Thanks
Last edited by Mark65 on Wed Apr 10, 2024 3:22 pm, edited 1 time in total.
2019 Qashqai Acenta Premium 1.5 dCi
2020 Suzuki SV650

Koolmacher
Posts: 10
Joined: Tue May 30, 2023 2:29 pm
Qashqai Model: Mk.3 Qashqai - J12 (2021+) New Model

Post by Koolmacher »

I ran mine under the edge of the roof liner by pulling the door seals off and behind the plastic trims on the a, b and c pillars. No airbags were harmed in the process 😁
Mark65
Posts: 102
Joined: Wed Jun 23, 2021 7:55 am
Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)

Post by Mark65 »

Hi,
I ran my rear camera from the rear screen through the plastics (the rubber cable joint between the hatch and body bit was very stiff) down along the floor under the trim where the doors are then up into the fuse box on the passenger side back up a pillar into roof lining then into camera, then the front camera power down through the A pillar back through the plastics to under the seat where the https://www.power-core.co.uk/products/6200lfp-plus.html dash cam battery is located, the power cable from it runs back into the fuse box to the 20a blower fuse.
Sounds messy but its straight forward really, it gives me up to 20hrs parking recording in low bit mode without affecting my car battery.
2019 Qashqai Acenta Premium 1.5 dCi
2020 Suzuki SV650
Post Reply