Apologies if already posted but I can’t find a thread.
When I picked up our J11B I thought the dealer had put she wrong pressure in the tyres as the OS was showing 34 and the NS 30. I have refilled them to ensure both front have 33 and both rears 30 PSI. Again after driving and checking both the OS are showing 33 and both NS 30. To rule out a faulty pump gauge I have checked each on an independent tyre pressure tester and as expected I have filled them correct and the machine was not faulty.
This tells me the car is picking up readings but has the wheel positions incorrect. I can’t seem to find anything regarding resetting the wheel position on the system?
TPMS Wheel Positions
front 33psi, rear 30psi check them when cold before you go driveing around. the go into menu settings on dash and save the correct pressure. don`t for get while driveing about and your checking the psi of the tyres it will be higher
-
- Posts: 788
- Joined: Sat Feb 04, 2017 11:34 am
- Location: South-East England
- Qashqai Model: Mk.2 Qashqai Facelift - J11b (2017–2021)
I had this issue once, it needed a trip to my local tyre place so they could be reassigned correctly, I waited though until I needed a new sensor so got it all sorted at the same time.
For me, the 2 fronts got reversed by accident when new tyres were fitted.
For me, the 2 fronts got reversed by accident when new tyres were fitted.
2019 1.3 DiG-T 160 Tekna, black (J11b)
prev 2015 1.2 DiG-T n-tec+, black (J11)
prev 2009 1.5 dCi Acenta, black (J10)
prev 2015 1.2 DiG-T n-tec+, black (J11)
prev 2009 1.5 dCi Acenta, black (J10)
I posted a how to some months back about swapping wheels around.
Sealers will tell you the system need to be calibrated or put on their machine.
You have done the pressure part by setting front and rear correctly - now just drive for a while and check the dash readings then.
I appreciate you may not have swapped wheels around - but the theory is still the same.
If no joy - then go down the sensor route
Sealers will tell you the system need to be calibrated or put on their machine.
You have done the pressure part by setting front and rear correctly - now just drive for a while and check the dash readings then.
I appreciate you may not have swapped wheels around - but the theory is still the same.
If no joy - then go down the sensor route
-
- Posts: 12
- Joined: Wed Oct 28, 2020 9:02 am
- Qashqai Model: Mk.2 Qashqai - J11 (2013–2017)
You may need to calibrate the tyre presure sensors. I did it once when swapping the tyres, and it works
Following this video
Following this video